Hi,
on page 29 of the manual it says:
"... Configuring Binary patterns - in SET-mode select either Velocity, Delay, Chop or Ratchet parameter using the buttons..."
My question:
How do I select Chop or Ratchet, as there are no buttons for these both?
I tried things like double-tapping the Velocity and Delay-buttons, holding them longer - no succuss.
I was not able to select Chop or Ratched.
How do I do this?
Thanks!
Chop and Ratchet are under the REPEAT button. Just press it repeatedly to cycle through the 3 parameters.
Then press PROGRAM to edit the pattern for the currently selected parameter.